All the advantage of a new approach to heating and comfort
One single unit for any heating, cooling and domestic hot water requirement with countless advantages from any point of view
The heat pumps PRANA can be used both for heating and for cooling systems for buildings. These reversible units also allow to produce domestic hot water.
Moreover, once the base requirement is covered with a PRANA heat pump, it can offer additional benefits and easy possibility to utilize further renewable resources. In fact PRANA units have one of their strong points in the simple integration with other systems. That is to say, they can be easily combined with a well designed solar system, thus enhancing the heat pump performances. This is a big difference between heat pumps and traditional boiler system: if this same solar system was installed with a boiler, the real benefits could be questionable as the carbon emissions from the boiler could outweigh the small benefits gained from the solar system.
PRANA is the solution of Climaveneta that combines care for the environment with the use of the most advanced technologies and facilities to ensure tangible benefits in terms of comfort and energy efficiency.
Free domestic hot water production
All PRANA units produce domestic hot water.
Thanks to the exclusive total heat recovery system, domestic hot water is free in DHW2 models.
During the cooling cycle, your system will remove heat and humidity from your home and will transfer this heat to the outdoor air. During the heating cycle, your system will remove heat and humidity from the outdoor air and will transfer this heat to your home. When operating in cooling mode your system will cool fluids (e.g water in the hydronic systems) and then it will transfer the heat to another fluid, air, water or ground. Thanks to heat pump it is possible to avoid heat wastes, using this heat for the production of hot water.
Optimized in each design and manufacturing choice, silent operation is among the strong points of PRANA units. The adoption, in air source units, of low noise fans with continuous regulation, guarantee minimum noise emission. Compressors are jacked and insulated in order to reduce vibrations. Dedicated acoustic panels for indoor units ensure the lowest noise emissions on the market.
Heating down to -20°C
Climaveneta has found the perfect solution for the operation of heat pumps in extreme weather conditions and the installation in harsh climate areas, down to -20°C. PRANA’s selection of the most suitable technological components and compressors ensure an efficient operation of heat pumps, which goes beyond the limits of the traditional units. This without using any other heating solution.
Ease of installation and complete reliability
PRANA units are plug & play, ready for installation and equipped with all the components necessary to install them in each system type: from low temperature systems based on radiant floor or fancoils, to more traditional systems with radiators. Low maintenance thanks to the use of sealed, factory-tested refrigerant circuits.
Integration among the components
Reliability is ensured by the installation of cutting-edge components and the introduction of central control system to coordinate the different components in the system. This eliminates communication inefficiencies and simplifies the installation, reducing the number of checks. All the models can be easily integrated with the existing heating system and with other renewable sources as solar systems, both thermal and photovoltaic.
Best air quality
Comfort does not exist without air renewal in new low-energy houses. Climaveneta has designed a controlled mechanical ventilation unit (SHAOCA) that ensures air renewal and purification inside the buildings. The heating, cooling of outdoor air, together with its purification and humidification is ensured by the use of an integrated cooling circuit and then released in the building. The renewed air is fresh all year long, maintaining a constant and adequate temperature in the ambient.